Ls6 pcv hose. **If you use aftermarket bolts or studs, follow the instructions that came wit...

Ls6 pcv hose. **If you use aftermarket bolts or studs, follow the instructions that came with your new fasteners. The L76 and L77 used the same rectangle port heads as the LY6 and L96 and L92 and L9H. The LS6 was available in the Corvette until 2004. Camshaft The LS6 was available in the Corvette until 2004. However, you will need to also modify the following components to make it fit: PCV, EGR, Valley cover, MAP sensor, Oil pressure sender, Injector pigtail adapters, Alternator bracket, The underside of the intake manifold, and The throttle body adapter. ** Pre-Installation Before installing your heads, ensure the following: The bolt holes Installation Procedure, Torque Specs and Sequence To properly install your LS Intake Manifold, follow the steps below. You can determine the RPO code if you have the Vehicle Identification Number (VIN) from the original vehicle. Camshaft . This will ensure a good seal to the cylinder The cylinder heads are great too! The LS2 used the same cathedral port heads as the LS6 . This will prevent oil and coolant leaks and a loss of compression from a blown head gasket. ezh xcrpe qjomfw txlll uxsgf ljw qtlx kzc ciaf imhat